Information

General Information
Exit Mould Spray is the No.1 selling mould remover in Australia and New Zealand. Eliminates germs and kills mould in 30 seconds.
Exit Mould attacks moulds at the source and the special detergent additive helps leave the surface sparkling clean.

Can be used indoors and outdoors.

- Bathroom and laundry.

- Tiles, grout and walls.

- Rubber bath mats.

- Fridge door seals.

- Boats.

- Under eaves.

- Concrete patios.

- Most mouldy areas.
Suitable For: Bathroom & laundry, tiles, grout and walls, rubber bath mats, fridge door seals, boats, under eaves, concrete patios, most mouldy areas.
Product Claims: No.1 selling mould remover in Australia and New Zealand.
Size: 500mL

Miscellaneous

Drug Interactions

Warnings Do not swallow. Vapour maybe harmful. Ensure adequate ventilation when using. May give off dangerous gas if mixed with other products. Wear protective gloves when using. Wear either old clothes, or a protective covering as product can cause discolouration of clothing and textiles. Wash hands after use. NOT TO BE TAKEN.

Corrosive. Strongly alkaline. May produce severe burns. Attacks skin and eyes.
CAUTION Keep out of reach of children. Read safety directions before using.
PRECAUTIONS Turn nozzle to off position after use. Do not squeeze trigger in OFF position as this may cause product to spit when turned ON. Store in a cool place out of direct sunlight. Do not place container on surfaces likely to suffer discolouration from spills. Dispose of empty packaging with household rubbish.
FIRST AID INFORMATION For advice, contact a Poisons Information Centre (Phone Australia 13 11 26; New Zealand 0800 764 766) or a doctor. If swallowed, do NOT induce vomiting. If in eyes, hold eyelids apart and flush the eye continuously with running water. Continue flushing until advised to stop by the Poisons Information Centre or a doctor, or for at least 15 minutes. If skin or hair contact occurs, remove contaminated clothing and flush skin and hair with running water.

Common Uses

Ingredients
Active Ingredients: Sodium Hydroxide 2.4g/L Alkaline Salts 1.2g/L Sodium Hypochlorite 42g/L

Directions 1. Pointing trigger away from the face, hold down the safety tab on top of the nozzle.

2. Turn nozzle to'ON' position. Do not squeeze the trigger when it is in'OFF' position as this may cause it to spit when turned ON.

3. Spray from 20-30cm away from targeted area. Leave for 30s for light stains and 10 mins for tough stains.

4. Rinse with water and then wipe off. Repeat steps 2 to 4 if required.

5. When finished, turn nozzle to'OFF' position, until safety tab locks in position.
SAFETY DIRECTIONS Avoid contact with textiles, unpainted metals, damaged paint surfaces or older enamel. Spot test on all surfaces before use in an inconspicuous area, particularly baths, basins, tiles, coloured grout and painted surfaces to ensure no discolouration occurs.
STORAGE INSTRUCTIONS Store in a cool place out of direct sunlight. Do not place container on surfaces likely to suffer discolouration from spills. Dispose of empty packaging with household rubbish.